Quantcast

Before & After Photos

Click on a photo to enlarge.

Air Sealing End Plates in West Simsbury, CT

End plates are at the top of every single wall in the home. The problem with end plates is there's generally a quarter inch to an inch gap left during construction of the home. This allows for air leakage which lets the cool air escape the home in the summer and warm air to escape in the winter.

When the hot air leaks into your attic in the winter, ice dams occur on your roof.  Ice dams can cause thousands of dollars of damage to your home! 

Air sealing end plates is the first, and most important, of multiple treatments to eliminate ice damming.

 

New Basement Door In West Simsbury, CT

This home owner in West Simsbury,CT had called us to his home to investigate his cold, dry basement. When we got there we noticed his basement door had seen better days. What we did was take out the old door and the old framing and went to work putting in new framing and putting in a new steel insulated door. It is important to put in new framing because the old wood was not pressure treated and was starting to rot away. After the door is installed, we insulate and air seal the pockets and seams so no air can get in when the door is closed. Now this basement will not have cold, dry air leak into the basement. 

Reducing Dust and Allergens in a home in Windsor, CT

This homeowner called to see what we could do to reduce the allergens that where coming into her home. During inspection, we saw fiberglass in the rim joists that was completely cover in dirt from wind washing. This was the reason why the dust was getting into the home.

We removed all of the dirty fiberglass insulation and sprayed the rim joist with our 2-part spray foam completely sealing it. Once sealed, dust and allergens cannot come into the home any longer. 

After Dr Energy Saver by Eco Energy Solutions completed this project, the homeowner has seen a dramatic reduction of dust and allergens allowing her to breathe easier!

Reducing Humidity In a Home In Windsor, CT

This home owner in Windsor, CT called us out originally to figure out why his bathroom was so cold! When the building science specialist was doing his inspection he found another issue that the home owner had in his basement. The issue was that his sump pump was sitting in a hole open to the basement with water in it. This is a problem because when that water evaporates, it becomes humidity and the dehumidifier has to take the water out of the air. But the dehumidifier was dumping the water back into the sump pump hole! It was a cycle that could not continue. To fix this problem, we installed a new sump pump with a lid so the water cannot evaporate back into the air. 

Now that Dr Energy Saver by Eco Energy Solutions has come in and installed a new sump pump, this home owner will not have to worry about his humiditiy issue again!

Make Basement Warmer With Foamax™ Insulation Board in Windsor, CT

Fogarty's Home Services was contacted by this Windsor, CT homeowner to help make his basement warmer. This home has poured concrete basement walls that are perpetually cold - about 17°F cooler than we like the interior of our homes, due to being below ground level. In the winter, the part of the foundation that sticks up above the ground is much colder than that. Heat moves from more to less. The dense concrete has a lot of mass and heat from the basement constantly flows into and through the wall by conduction. You can never heat them up. Heat that comes off the heater and hot water heater was being wasted - lost into the cold concrete, instead of warming the basement and floors above it. In the summer, warm humid air from outside hits the cold basement walls and condensation forms, supporting mold. This is why the homeowner's basement and floors above the basement were cold. Fogarty's Home Services made this home more comfortable by installing foam insulation board is on the basement walls with Dr. Energy Saver's proprietary Foam-site fasteners. But not just any foam - Polyisocyanurate foam has the flame retardant properties to satisfy building codes to leave it exposed in a basement - unlike expanded or extruded polystyrene foam (EPS, XPS). In addition, the "polyiso" board has a foil facing to reflect heat so the insulation isn't doing all the work by itself. This happy customer will now have a warmer basement and much warmer floors.

Our Products
Finishing Ideas
About
Learning Center
Become a Dealer
Free Estimate